After Your Installation: A Practical Care Guide
Care guidance after a clutch, header, oil pump gear, fuel system or supercharger installation. Follow your parts-specific handover and break-in instructions.
Start with your specific handover instructions
Care requirements depend on the installed components and vehicle combination. Keep the manufacturer's instructions and the shop's job-specific guidance together. Confirm fuel, calibration, break-in and any requested follow-up checks before pickup.
Clutch installations
Follow the break-in procedure for your exact clutch. Different clutch designs have different requirements; highway mileage alone may not provide the engagement cycles a manufacturer requires. Avoid launches, hard acceleration and dyno testing until the specified break-in is complete.
Headers and exhaust work
Report new exhaust smells, persistent ticking, contact noises or warning lights. Have the installation checked rather than assuming every new sound is normal. Do not attempt to tighten or inspect hot exhaust components.
Oil pump gears and crank sprockets
Continue the oil and filter maintenance specified for your engine and combination. Upgraded gears and sprockets are not a cure for an existing oil-pressure problem and do not eliminate every possible engine failure.
Superchargers and fuel systems
Use the fuel required by the approved calibration. Follow the kit manufacturer's belt, lubrication and inspection guidance where applicable. Confirm calibration readiness before hard acceleration. If you notice a fuel smell or visible fuel leak, stop safely, shut the engine off and arrange assistance rather than continuing to drive.
When to contact us
Contact the shop promptly about new symptoms. A low oil-pressure or overheating warning calls for stopping safely and arranging help. Note when the symptom occurs and share a clear description or photo taken safely. Ask which checks apply to your job and when they should occur.